Canon MP980 - PIXMA Color Inkjet Easy Setup page 3

7
Check the Authentication Type
and click Next.
10
Click Connect.
4
1
A
If you need to move the machine to another
location, you may now turn it off (A). Place the
machine to where you will use it, then turn it
back on.
5
• To troubleshoot the setup, refer to the printed manual: Network Setup Troubleshooting.
• When using Mac OS X v.10.5.x, the machine's Card Slots are not accessible when using the machine over a network. To access the Card Slots from a computer using Mac OS X v.10.5.x, a
USB cable must be used.
Mac OS X v.10.5.x
1
Wait for a while, then select Canon MP980
series and click Add.
When selecting the printer to add, make sure the kind
listed for the printer is canonijnetwork.
It may take up to 15 seconds for the network printer to
appear in this list.
8
Enter your Passphrase (network password) and click Next.
For the encryption method, the default setting (TKIP: Basic Encryption)
should be used.
11
Measu re Wireless P erformance
2
On the Connection Performance
Measurement dialog box, click Next.
Ad d th e Ma chine
2
Select Canon MP980 series Network in TWAIN
Data Source Name and the MAC address of
the machine in Network Device List, then click
Apply to use the machine as a scanner.
9
Check the settings and click Finish.
a. Disconnect the USB cable.
b. Click Next.
3
Confirm the measurement results, then click Finish.
Ensure that is displayed in Connection performance between the printer
and the access point.
The Printer Setup Utility and Canon IJ Network Scanner Selector will start up.
• To check whether the new location is better, click Remeasurement.
Measurement of the communication status is performed again.
3
Confirm that a check mark is displayed,
then click Exit to close the dialog box.
This completes the installation.
The device is now installed and ready to use over
the AirPort network.