GE 23 Owner's Manual And Installation page 7

About CustomCoolY C Applia, ces.com
How it Works
The CustomCool
TM
feature
is a s_steIn of
dampe_, a tim, a temperature thermistor
and a heater. Depending on the flmction
selected, a combination at these will be
used to quickly chill items, thaw items or
hold the pan at a specific
teillperattlre.
The pan is tightly sealed to prevent the pen's
temperature fl'onl causing temperature
fluctuations in the rest of the retiigeratm:
Some
CustomCoolmodels teature
a beverage
centei: It is designed to store beverages at
cokler wmperamres. Select the Beverage
Center pad if you like to kee I) extra-chilled
refl'eshments on hand.
The controls fin" this pan are located at the
top of the refi_gerator with the temperature
controls.
ExpressThaw
TM
ExpressChfll
TM
How to Use
O Erupt} the pan. Place the Chill/Thaw
tra} in the pan. Place the items on the
tra} and close the pan completely.
0 Select the ExpressThaw: _ ExpressChilY_
or SelectTemp
TM
pad. The display and
SkTlight will con/e on. Tap the pad
until tile light appeai_ next to the
desired setting. Lrse the chart to
detemfine the best setting to use.
To stop a feature before it is
finished, trip that teature's pad
until no options are selected and
the display is off.
During ExpressThaw and
ExpressChill,tile displa_ on the
controls will count down the time
in the cycle.
_Mier the
ExpressThaw
cycle is
conq)lete, the pan will reset to the
MEATsetting (32°F) to help preserve
thawed items until they are used.
The displayed actual wmperamre _ff
the CustomCoolpan may vmy slightly
ti'om the SETtemperature based oil
usage and operating environment.
NOTE."For food safety reasons,it is recommended
that foods be wrapped in plastic wrap when using
ExpressThaHz This will help contain meat juices
and improve thawing performance.
How to Remove and Replace the Drawer
Toremove: _ I,ock all fi)ur swing locks by rotating
O Pull the drawer out to the stop position, thenl to the lock position.
0 Rotate all fi)ur swing locks to the mdock
position.
O i,ifi the fl'ont of the drawer
up and ()tit.
Toreplace:
O
Make sure all four swing locks are in the
unlock position.
Place the sides of the drawer into the
drawer supports, making sure the swing
locks fit on the drawer
slots.