Asus P65UP5-PKND User Manual page 26

9. Turbo LED Switch (TB LED)
The baseboard's turbo function is always on. The turbo LED connection is la-
beled here but the LED will remain constantly lit while the system power is on.
You may wish to connect the Power LED from the system case to this lead.
10. SMI Suspend Switch Lead (SMI)
This allows the user to manually place the system into a suspend mode or "Green"
mode where system activity will be instantly decreased to save electricity and ex-
pand the life of certain components when the system is not in use. This 2-pin con-
nector connects to the case-mounted suspend switch. If the switch is not available,
you can use the turbo switch. SMI is activated when it detects a short to open mo-
ment; leaving it shorted, therefore, will not cause any problems. This may require
one or two presses depending on the switch's position. Wake-up can be controlled
through the BIOS but the keyboard will always wake up (the SMI lead cannot wake
up) the system. If you want to use this connector, the "Suspend Mode" under Power
Management Setup of the BIOS SOFTWARE must be set to Enable.
11. Reset Switch Lead (RESET)
This 2-pin connector connects to the case-mounted reset switch to allow the
restarting of your computer without having to turn off it off. This is a preferred
method of restarting to prolong the life of the system's power supply.
12. System Power LED (KEYLOCK)
This 3-pin connector connects the system power LED, which lights when the
system is powered on and blinks when it is in sleep mode.
13. Keyboard Lock Switch Lead (KEYLOCK)
This 2-pin connector connects to the case-mounted key switch to allow key-
board locking.
14. Speaker Connector (SPEAKER)
This 4-pin connector connects to the case-mounted speaker.
System Panel Connectors
26
III. INSTALLATION
Turbo or
Power LED
SMI Lead
Reset SW
ASUS P/I-P65UP5 User's Manual
+5V
Power LED
NC
+5V
GND
GND
LOCK
Keyboard Lock
GND
GND
+5V
Speaker
GND
Connector
GND
SPKR
GND