Asus P65UP5-PKND User Manual page 24

5. Primary/Secondary IDE Connectors (Two 40-pin Block)
These connectors support the provided IDE hard disk ribbon cable.
After connecting the single end to the board, connect the two plugs at the other
end to your hard disk(s). If you install two hard disks on one connector (chan-
nel), then you must configure a second drive as Slave mode by setting its jumper
according to your hard disk jumper diagram. You may also configure two hard
disks to be both Masters using one ribbon cable on the primary IDE connector
and another on the secondary IDE connector. A new BIOS feature allows SCSI
hard drive bootup (see "HDD Sequence SCSI/IDE First" in the BIOS FEA-
TURES SETUP of the BIOS software). (Pin 20 is removed to prevent insert-
ing in the wrong orientation when using ribbon cables with pin 20 plugged).
IDE (Hard Disk Drive) Connectors
6. Power Connector (12-pin block)
This connector connects to a standard 5 Volt power supply. To connect the leads
from the power supply, ensure first that the power supply is not plugged. Most
power supplies provide two plugs (P8 and P9), each containing six wires, two of
which are black. Orient the connectors so that the black wires are located in the
middle.
AT Power Connector
Using a slight angle, align the plastic guide pins on the lead to their receptacles
on the connector. Once aligned, press the lead onto the connector until the lead
locks into place.
24
III. INSTALLATION
Pin 1
+5V
GND
+12V
PG
Power Connector
on Motherboard
ASUS P/I-P65UP5 User's Manual
Orient the red stripe on the
IDE ribbon cable to Pin 1
Secondary IDE Connector
Primary IDE Connector
RED
RED
RED
-5V
WHT
BLK
BLK
BLK
BLK
-12V BLU
YLW
RED
+5V
ORG
Power Plugs from
Power Supply