ASROCK H61TM-ITX Quick Installation Manual page 12

Consumer Infrared
Module Header
(7-pin CIR1)
(see p.2, No. 5)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2, No. 26)
1. High Definition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow
the instructions in our manual and chassis manual to install your
system.
2. If you use an AC'97 audio panel, please install it to the front panel
audio header by the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to
OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. To activate the front mic.
For Windows
Select "Mixer". Select "Recorder". Then click "FrontMic".
For Windows
64-bit OS:
Go to the "FrontMic" Tab in the Realtek Control panel. Adjust
"Recording Volume".
12
CIR input
+5VA
Learn-in
LED
1
+5VA
NC
GND
®
XP / XP 64-bit OS:
®
8 / 8 64-bit / 7 / 7 64-bit / Vista
ASRock H61TM-ITX Motherboard
This header can be used
t o c o n n e c t t h e r e m o t e
controller receiver.
This is an interface for the
front panel audio cable that
allows convenient connec-
tion and control of audio
devices.
TM TM
/ Vista