Electrolux LAVAMAT 62610 User Information page 19

Problem
The washing machine
vibrates when operating
or is not stable.
Water is running out
from under the washing
machine.
Washing water is foam-
ing excessively. At the
end of the washing cy-
cle, the spin stops.
E20 appears.
indicator (END)
flashes 2x, at the same
time an acoustic signal
sounds 2x.
(Problems with water
outflow)
Conditioner not rinsed
in, w compartment for
additives is filled with
water.
Possible cause
The transit bar has not been
removed.
The screw feet are not cor-
rectly adjusted.
There is very little washing
in the drum (e.g., just one
bathrobe).
Screw connection on the in-
let hose is leaking.
Drain hose is leaking.
Drain pump cover is not
closed properly.
Washing was caught in the
door.
Emergency drain hose is
leaking.
Probably too much deter-
gent has been used.
Kink in drain hose.
Maximum pumping height
of 1m exceeded.
Drain pump is blocked.
For sink spigot connections:
The sink spigot is blocked.
Conditioner insert in the
compartment for additives
is not correctly attached or
is blocked.
Remedy
Remove the transit bar.
Adjust the feet as described
in the installation and con-
nection instructions.
Operation is not affected by
this.
Screw the inlet hose on
tightly.
Replace drain hose.
Close the cover properly.
Load washing carefully for
the next wash.
Close off emergency drain
hose properly.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
Straighten the hose.
Please contact the Customer
Care Department.
Switch off the appliance.
Disconnect the power plug.
Clean the drain pump. Re-
move foreign bodies from
the pump housing.
Clean the sink spigot.
Clean the detergent drawer,
insert the conditioner insert
firmly.
19