Troubleshooting - Electrolux EWS 105410 A User Manual

Hide thumbs Also See for EWS 105410 A:
Table of Contents

Advertisement

4. Install again the inlet hose. Make sure
that the couplings are tight to prevent
leakages.
5. Open the water tap.
EMERGENCY DRAIN
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (5) of 'To
clean the drain pump'.
If necessary, clean the pump.
When you drain the water with the emer-
gency drain procedure, you must activate
again the drain system:
1. Put 2 litres of water in the main wash
compartment of the detergent dispens-
er.

TROUBLESHOOTING

The start of the appliance does not occur or
it stops during operation.
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
With some problems, the display
shows an alarm code:
• E:00 - The appliance door is open or not
closed correctly or it does not fill with wa-
ter.
Problem
The appliance does not
start.
Possible cause
The mains plug is not connec-
ted in the mains socket.
The fuse in the box fuse is
damage.
The appliance door is open.
You do not press the start but-
ton
2. Start the programme to drain the wa-
ter.
FROST PRECAUTIONS
If the appliance is installed in an area where
the temperature can be less than 0 °C, re-
move the remaining water from the inlet
hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Remove the water inlet hose
4. Put the two ends of the inlet hose in a
container and let the water flow out of
the hose.
5. Empty the drain pump. Refer to the
emergency drain procedure
6. When the drain pump is empty, install
the inlet hose again.
Warning! Make sure that the
temperature is more than 0 °C before
you use the appliance again.
The manufacturer is not responsible for
damages caused by low temperatures.
• E:01 - The appliance continuously fills
and drains the water or it does not drain
or do the spinning phase.
• E:02 - Technical malfunction, contact the
service centre.
• E:03 - Technical malfunction, contact the
service centre.
Warning! Deactivate the appliance
before you do the checks.
Possible solution
Put in the mains plug.
Replace the fuse.
Close the door firmly.
Press the start button.
electrolux 15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ews 125410 a

Table of Contents