Care And Cleaning - Electrolux EWS 105410 A User Manual

12 electrolux
If the temperature and level of the wa-
ter in the drum are too high, you can-
not open the door.
To open the appliance door:
• Do the steps 1 and 2 again.
• Wait for some minutes.
• Make sure that no water is in the
drum.
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The display shows the End symbols.
• Turn the programme knob to
tivate the appliance.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Keep the door ajar, to prevent mildew
and odours.
• Close the water tap.
The washing programme is completed,
but there is water in the drum:
– The Rinse Hold function or a programme
that stops with water in the drum is set.
– The door stays locked and the start but-
ton indicator flashes.

CARE AND CLEANING

Warning!
Disconnect the appliance from the mains
supply before you clean it.
EXTERNAL CLEANING
Clean the appliance only with soap and
warm water. Fully dry all the surfaces.
Caution! Do not use alcohol, solvents
or chemical products.
DESCALING
The water we use contains limescale. If it
becomes necessary, use a water softener
to remove limescales.
Use a special product made for washing
machines. Obey the instructions that you
find on the packaging of the manufacturer.
Do this separately from the laundry wash.
MAINTENANCE WASH
With the low temperature programmes it is
possible that some detergent stays in the
drum. Make regularly a maintenance wash.
To do this:
– You must drain the water before to open
the door.
To drain the water:
1. If necessary, decrease the spin speed.
2. Press the start button. The appliance
drain the water and spin.
3. When the programme is completed:
– The display shows the End symbols.
– You can open the door.
4. Turn the programme knob to
activate the appliance.
to deac-
STAND BY
After some minutes the end of the washing
programme, if you do not deactivate the
appliance, the energy saving status acti-
vates.
The energy saving status decreases the en-
ergy consumption when the appliance is on
standby.
• The brightness of the display goes off.
• The display shows the symbol End.
• All indicators go off.
Press one of the buttons to deactivate the
energy saving status.
• Empty the laundry from the drum.
• Set the hottest cotton wash programme
• Use a correct quantity of powder deter-
gent with biological properties.
After each wash, keep the door open for a
while to prevent mould and to let unpleas-
ant smells go out.
DRUM
Regularly examine the drum to prevent
limescale and rust particles.
Only use special products to remove rust
particles from the drum.
To do this:
• Clean the drum with special product for
stainless steel.
• Start a short programme for cotton at the
maximum temperature with a small quan-
tity of detergent.
DOOR SEAL
Regularly examine the seal and remove all
objects from the inner part.
to de-