Listening To The Radio - Emerson ES920 Owner's Manual

Listening To The Radio

1.) Press the STANDBY
system ' On' .
The display lighting comes on and the
display shows "HELLO".
2.) Press the TUNER/BAND button to select the Tuner function.
An AM or FM frequency will appear on the
display.
Press the TUNER/BAND button again to
switch between the AM and FM bands if
necessary.
3.) Tune to the desired station as follows:
• Manual Tuning
Repeatedly press the
frequency of the desired station. Use the Manual Tuning method to tune to
weak or distant stations that are not strong enough to be recognized by the
Automatic Tuning system.
• Automatic Tuning
Depress and hold the
release the buttons. The Tuner will search up or down the band for the next
strong signal and stop on that station. Repeat this procedure until the tuner
stops on your desired station.
4.) If you tuned to an FM Stereo station the ST indicator will appear in the display.
If the FM Stereo reception is noisy or weak, press the ST/MONO button to
select the FM Mono mode.
5.) Adjust the VOLUME and EQ controls to the desired settings.
6.) When you are finished listening press the
STANDBY button to return the system
to the Standby (Off) mode.
The display lighting will become dimmer and the display changes from radio
frequency to correct time.
ES920_102104.p65
button to turn the
or buttons until the display shows the exact
or buttons until the display begins to move, then
20
20 21/10/2004, 12:06