Functions - Electrolux EW 1077 F Instruction Booklet

If you have selected the Anti-crease option
zero will not flash.
13 START/PAUSE button
This button has three functions:
Start - Pause - Draining of water/Spin
Start
After having selected the required programme, press
this button to start the machine; the corresponding
pilot light stops flashing.
If you have selected the delayed start, the machine
begins its countdown. The duration of the
programme or the delay appears on the display.
Pause
To interrupt a programme which is running, depress
the Start/Pause button: the corresponding pilot light
starts start to flash.
To restart the programme from the point at which it
was interrupted, press the START/PAUSE button
again.
Draining of water/Spin
By depressing the Start/Pause button
• The water of programme "A" (Soak) is emptied out
• The water of the last rinse on programmes with
Anti-crease option is emptied out and the
laundry is spun.
14 Programme progress display
, the
By selecting the wash programme, the pilot lights
corresponding to the various phases making up the
programme come on.
After the machine has started, only the running
phase pilot light stays on. When the programme has
finished, the End
The END pilot light flashes in the event of
operating problems.
At the same time one of the following lights starts to
flash and an alarm code appears on the display.
E10 + = the machine does not fill
E20 + = the machine does not empty
E40 + = the door has not been closed
To eliminate the problem, see paragraph "Something
not working".
If at the end of the programme the pilot light
flashes this means that the drain filter must be
cleaned.

Functions

End of programme
When the door locked light has gone out, the door
can be opened. The light
programme progress display illuminates.
A flashing zero appears on the display.
Switch the machine off and remove the laundry.
Turn the programme selector dial to O.
Altering a programme
You can alter the programme before it starts.
When the programme has started, you can only
reset it by turning the programme selector dial to O
and then you can select the new programme.
Start it by depressing the START/PAUSE button.
Interrupting a programme
Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding light
13
pilot light comes on.
(END) on the