Table of Contents
Advertisement
10
Prior to using for the first time
Setting electronically:
1. Press the ON/OFF button.
If the only LED indicator illuminated is one that belongs to a programme button,
this means that this dishwashing cycle has been activated. The dishwashing
cycle must be deselected:
Press function buttons 1 and 2 simultaneously for approx. 2 seconds.
The LED indicators of all the programme buttons that can be selected light up.
2. Press function buttons 1 and 2 simultaneously and keep them pressed.
The LED indicators for function buttons 1 to 3 will flash.
3. Press function button 1.
The LED indicator for function button 1 will flash.
The multi display will indicate the hardness setting.
4. Pressing function button 1 increases the hardness setting by 1.
(Exception: hardness setting 1 follows hardness setting 10).
5. When the hardness setting is correct, press the ON/OFF button.
The hardness setting is now saved.
If the water softener is set electronically to "1", this switches off the control in
dicator for special salt.
1)
in °d
51 70
43 50
37 42
29 36
23 28
19 22
15 18
11 14
4 10
below 4
1) (°d) German degree, measure of the hardness of water
2) [mmol/l] millimol per litre, international unit for water hardness
3) On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting
Water hardness
2)
in mmol/l
Range
9,0 12,5
7,6 8,9
6,5 7,5
5,1 6,4
4,0 5,0
3,3 3,9
2,6 3,2
1,9 2,5
0,7 1,8
below 0.7
Adjusting the hardness setting
Manual
IV
2*
III
II
I/II
1
I
Indication on
the multi dis
Electronic
3)
10L
10
9
8
7
6
5*
4
3
2
1
no salt
necessary
play
.
9L
8L
7L
6L
5L
4L
3L
2L
1L
Advertisement
Table of Contents
