Electrolux FAVORIT 60870 User Manual page 34

Hide thumbs Also See for FAVORIT 60870:
Table of Contents

Advertisement

34
What to do if...
Malfunction
The cycle indicator for the se
lected dishwashing cycle is
flashing:
the control indicator
lit,
Å 10
fault code
in the multi display
(Problems with water inlet).
The cycle indicator for the se
lected dishwashing cycle is
flashing,
Å 20
fault code
in the multi display
(there is water in the dish
washer's internal dispenser).
Å 30
Fault code
in the multi display.
The control indicator
The control indicator
The cycle is not starting.
Water tap is blocked with
limescale or faulty.
The tap is turned off.
The filter (where present) in the
threaded hose fitting on the
tap is blocked.
is
Filters in the base of the wash
is displayed
ing compartment are blocked.
Water inflow hose
has not been correctly posi
tioned.
The sink outlet is blocked.
Water drain hose
is displayed
has not been correctly posi
tioned.
is displayed
The anti flood system has been
triggered.
The door of the dishwasher is
is lit.
open.
The indicator
mind you to check the dish
washer's filters occasionally
is lit.
and to clean them, if necessary.
It lights up at regular intervals,
regardless of how clean the fil
ters are.
The mains plug is not
plugged in.
A fuse in the house's wiring
system is defective.
For dishwasher models with a
delay start timer:
A start time has been selected.
Possible cause
is there to re
Remedy
Check the water tap and have
it repaired if necessary.
Turn the tap on.
Clean the filter in the threaded
hose fitting.
Cancel the dishwashing cycle
(see chapter: Starting a dish
washing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing cy
cle again.
Check the position of the hose.
Clean out sink outlet.
Check the position of the hose.
First shut off the water tap,
then switch off the appliance
and contact the Customer Care
Department.
Close the dishwasher door.
The indicator goes out auto
matically at the start of the
next dishwashing cycle.
Plug in the mains plug.
Replace the fuse.
If the dishes are to be washed
immediately, cancel the delay
start.

Advertisement

Table of Contents
loading

Table of Contents