Echo CS-341 Instruction Manual page 12

5. Turn switch (A) to "RUN" position (I).
6. Pull choke (B) all the way out (closed position).
7. Push purge bulb (C) 10 times.
8. Pull starter handle several times until first firing sound is heard.
(Secure unit on ground with your knee or foot.) (5 - 6 pulls
maximum.)
9. Push choke (B) all the way in. (open position)
10. Pull starter handle again.
NOTE
If engine does not start after 5 pulls, repeat instructions.
when engine is haRD to staRt
WARNING
Clutch engages and chain may rotate when engine is started
with throttle control latch engaged. Never use the throttle control
latch for cutting. Use only when starting the engine.
1. Ensure that there is fuel and chain oil in the tanks.
2. Move chain brake lever fully forward to lock chain brake before
starting.
3. Lay unit on a flat, clear area and keep bar and chain clear of all
obstacles.
4. Press throttle control lockout down, squeeze throttle trigger, and
push in throttle control latch.
5. Turn switch (A) to "RUN" position (I).
6. Pull starter handle.
7. When engine starts, immediately squeeze throttle trigger to
release the latch otherwise damage to clutch may result.
NOTE
Do not pull starter rope out to the maximum possible position.
Do not allow recoil handle to snap back against the casing.
11
12
C
B
Securely hold the saw
A
C
B
Securely hold the saw