Notes For Figures 15, 16, And 17; Figure 17. J2 Option Select Header - Seagate ST373405LW - Cheetah 73.4 GB Hard Drive Product Manual

38
*
Additional notes on these
functions in section 8.1.2.
J2
Jumper Plug
(enlarged to
show detail)
Figure 17. J2 option select header
8.1.1

Notes for Figures 15, 16, and 17.

[1] Notes explaining the functions of the various jumpers on jumper header connectors J2, J5, and J6 are
given here and in Section 8.1.2. The term "default" means as standard OEM units are configured with a
jumper on those positions when shipped from factory. "Off" means no jumper is installed; "On" means a
jumper is installed. OFF or ON underlined is factory default condition.
The PCBA on LC models does not have connector J5. The J5 connector signals conform to SFF-8009
Revision 2.0, Unitized Connector for Cabled Drives, signal assignments for auxiliary connectors.
[2] These signals are also on 80-pin J1 I/O connector. See Tables 14 and 15.
[3] Voltage supplied by the drive.
Jumper
Positions
Force single-ended bus mode
Delay Motor Start
Enable Remote Motor Start
Write Protect
Parity Disable
Reserved
Term. Power to SCSI Bus
J6
Drive
Front
Cheetah 73LP Product Manual, Rev. C
J2 Pin 1
R R
S D M W P E E T
E S E P D S S P
[3]
(applies to "LW" model only;
reserved on "LC" model)
J2