Dimplex DWF1146GP Owner's Manual page 6

Fireplace Installation
!
NOTE: Wall anchors must be installed in the
appropriate wall locations to fasten the wall
bracket through the remaining holes (Figure 3). For
example, if you plan to secure the bracket to studs
through holes A&F, install anchors centered on
holes B, C, D, and E.
Figure 3
Screw
③
hold the wall-mounting bracket on the wall and
mark the location of ONE (1) of the mounting holes.
④
Place the bubble level onto the top of the wall-
mounting bracket.
⑤
Adjust the wall-mounting bracket so the bubble
on the level is centered between the two black lines.
⑥
Mark five (5) other mounting screw locations, on
the wall, ensuring that the wall bracket stays level.
⑦
Install the supplied wall anchors on the marked
locations by placing a #2 Phillips screwdriver into the
recess of the anchor.
⑧
Press the anchor into the wall in the desired
marked position while turning the anchor clockwise
until it is flush with the wall.
⑨
Insert the wall anchor screws through the wall
bracket and thread into the wall anchors. Tighten the
screw (Figure 3).
⑩
Install the remaining screws through the bracket
and into the wall studs as required.
!
NOTE: At least two of the mounting screws must
be installed into a wall stud.
⑪
Remove glass assembly (Figure 4).
⑫
Mount the unit on the wall as shown (Figure 5).
⑬
Fix the unit in place by inserting two (2) screws
through 2 of the 4 available back panel holes, and into
the wall studs. If studs are unattainable please use
wall anchors (Figure 6).
⑭
With the glass assembly out remove the 4 screws
holding the top frame piece in place - 2 on each end.
(Figure 7)
6
Wall anchor
Wall
bracket
Figure 4
2
1
Figure 5
Wall Bracket
Supports
Wall Bracket
Figure 6
Panel Mounting holes
3
www.dimplex.com