Dakota Digital MCL-2002 Manual page 2

Mounting in a Dash with Cable Drive speedometer and rubber mounts
Remove the dash
Unbolt and unplug the factory gauge
Install the rubber mounts and foam tape around the new Dakota
Digital gauge. The tape should apply to the side of the gauge can
and be against the bottom of the bezel; this just fills the opening in
the dash.
Insert new gauge from front of dash
Use supplied lock washers and nuts to
attach the gauge to the factory dash
Now install the cable drive sender,
when required, as shown with the supplied
bracket and screws
Reinstall the dash
Mounting in a dash with factory electronic speed sensor
L-Bracket (supplied)
Dakota Digital Gauge
MCL-2002 (-R)
Rubber Mounts
Dakota Digital Gauge
MCL-2002 (-R)
Factory Gasket
Foam Tape
Cable Drive Speed Sensor
With Mounting Hardware
Factory Dash Panel
#8 Lock Washer
8-32 x ½" Nut
Factory Dash Panel
#8 Lock Washer
8-32 x ½" Screw
MAN# 650280:D