Rear Panel Description - D-Link xStack DGS-3200 Series Hardware Installation Manual

xStack
LED
Console
Power
Port LEDs
Combo SFP Ports

Rear Panel Description

The rear panel contains an AC power connector.
The AC power connector is a standard three-pronged connector that supports the power cord. Plug-in the female connector of the
provided power cord into this socket, and the male side of the cord into a power outlet. The Switch automatically adjusts its power
setting to any supply voltage in the range from 100 ~ 240 VAC at 50 ~ 60 Hz.
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Description
This LED will blink green during the Power-On Self Test (POST). When the POST is
finished, the LED goes dark. The indicator will light steady green when an active console
link is in session via RS-232 console port.
This LED will light green after powering the Switch on to indicate the ready state of the
device. The indicator is dark when the Switch is no longer receiving power (i.e powered
off).
One row of LEDs for each port is located above the ports on the front panel. The indicator
above the left side of a port corresponds to the port below the indicator in the upper row
of ports. The indicator above the right side of a port corresponds to the port below the
indicator in the lower row of ports. A steady green light denotes a valid 1000Mbps link on
the port while a blinking green light indicates activity on the port (at 1000Mbps). A steady
amber light denotes a valid 10 or 100Mbps link on the port while a blinking amber light
indicates activity on the port (at 10 or 100Mbps). These LEDs will remain dark if there is
no link/activity on the port.
LED indicators for the Combo ports are located above the ports and numbered 1/9 and
2/10 (DGS-3200-10)/1/15 and 2/16 (DGS-3200-16). A steady green light denotes a valid
1000Mbps link on the port while a blinking green one indicates activity on the port (at
1000Mbps). A steady amber light denotes a valid 100Mbps link on the port while a
blinking amber one indicates activity on the port (at 100Mbps). These LEDs will remain
dark if there is no link/activity on the port.
Figure 1- 5. Rear panel view of DGS-3200-10
Figure 1- 6. Rear panel view of DGS-3200-16
15