Table of Contents
Advertisement
ARMING WITHOUT THE
REMOTE CONTROL
You can arm the system without using
a Remote Control by pressing the
ARM button on the Console. Arming
this way will ALWAYS arm the sys-
tem in the Delay Mode.
SOUNDING THE
PANIC ALARM
HT544 and KF574 Remote Controls
Pressing ARM and DISARM (at the
same time) trips the alarm, even if the
system is not armed, but it doesn't dial
out unless you arm the system first.
SH624 Remote Control
Pressing (PANIC] trips the alarm,
even if the system is not armed, but it
doesn't dial out unless you arm the
system first.
TROUBLE ALARM
If you hear a repetitive trouble alarm
when you try to arm the system, there
is a problem and the system does not
arm. You can:
Correct the problem - First press
[DISARM] to stop the trouble
alarm. Then, correct the problem.
Then, arm the system again.
Ignore the problem - While the
trouble alarm is sounding, press
[BYPASS]. The indicator(s) for the
problem zone(s) flash rapidly.
Press [ARM] to arm the system.
The problem zone(s) is/are not be
protected but all other zones arm.
18
TO SEE THE STATUS
OF ZONES 9-16
If there is a problem with zones 9 -16,
you do not see a flashing zone light
but will hear the trouble alarm if you
try to arm the system. Press and hold
[BYPASS]. This bypasses the problem
and lets you see which zone is report-
ing the problem. If you do not want to
bypass the problem, correct the prob-
lem then arm the system again.
AFTER AN ALARM
When you disarm the system after an
intrusion (or 4 minutes after the alarm
trips) the siren turns off and the lights
which were flashing remain on (to let
you know there has been an intrusion).
The ARMED indicator flashes and the
zone indicator for the violated zone is
on. Press LIGHT ON] or [LIGHT
OFF] on the Remote Control to turn
off the zone indicator and the flashing
ARMED indicator. Press [LIGHT
OFF] to turn off X-10 Modules set to
the same Housecode AND Unit Code
as the Console.
Hide quick links:
Advertisement
Table of Contents
