Setting Up Motion Detectors - X-10 POWERHOUSE PS561 Owner's Manual

SETTING UP AND USING MOTION DETECTORS
This procedure initializes each Motion
Detector so that the Console recogniz-
es it. You install a Motion Detector
just like you install Door/Window
Sensors. Each Motion Detector will be
assigned to one of the 16 zones.
1. Install a 9-volt alkaline battery in
the battery compartment on the
front of the Motion Detector.
2. Set the Console's slide switch to
INSTALL.
Press [CODE] on the back of the
3.
Motion Detector with a pencil.
Press [TEST] on the back of the
4.
Motion Detector. The Console's
next unused zone indicator lights
and the Console sounds a tone to
indicate that the receiver accepted
the Motion Detector.
Place one of the enclosed num-
5.
bered stickers on the Motion Detec-
tor to show its zone number.
To set additional Motion Detec-
6.
up
tors, (up to 16 zones) repeat Steps
l-5.
7. Set Console to RUN (BUSY light
stays on for 15 seconds).
Home/
Away
USING THE SP554A.
Set switch on left (looking at back) to
(1) to trip alarm if ANY movement is
detected (most sensitive). Set switch to
(2) to trip alarm if two movements de-
tected or continuous movement detect-
edin a short time (less sensitive to pets).
Using SPS54A with SH624:
Set switch on right to Home/Away.
Use the SH624 Remote Control to arm
the system in the Away mode (which
arms Door/Window Sensors AND
SP554As) or in the Home mode (which
arms Door/window Sensors only).
Using SPSS4A with HT544/KF574:
Set switch on right to NORMAL and
switch on left to (1) or (2) to include
SP554A when arming system. Set
switch on left to OFF if you don't want
it to arm (i.e. when you're at home).
Testing the SPS54A
Place SP554A within 100 feet of Con-
sole. Walk past SP554A. Console
chimes. Wait 20 seconds before re-
peating test (the SP554A has a 20-sec-
ond lock-out to extend battery life).
Arm system, walk past SP554A: alarm
trips. Press [DISARM] on Remote.
1
OFF
1
2
OFF
2
0
Home/
Away
N
0
4
L
11