Advertisement
INPUT AND OUTPUT CONNECTIONS
The OBH-11 has two pairs of stereo phono sockets (RCA jacks) on the rear panel.
The first pair is the Input from any line level source, direct from the source or via the
tape output of an amplifier. The second pair of sockets, marked 'Output', are to chain
link the signal onto the next component in the system. Therefore, the OBH-11 can
be driven from the Tape Output of an amplifier and the second set of sockets can be
used to link the signal to the Tape recorder input. There is a 2.1mm DC power jack,
with centre positive pin, for connection to a custom Creek OBH type power supply
adaptor. On the front panel there is one 1/4" (6.3mm) stereo socket, for plugging in
the headphones.
INSTALLATION AND OPERATION
Connect the OBH power supply adaptor to the mains socket. Find a suitable place
for the OBH-11 and plug the DC power lead into the rear panel DC jack socket.
Connect a pair of high quality interconnect cables from the output of the source to
the input sockets on the rear of the OBH-11. Refer to the wiring diagrams showing
the different options for connecting the OBH-11 to your system.
Plug the headphones into the socket on the front panel. Push the On/Off button on
the rear to power-up the OBH-11. The small green LED on the front panel will light
when it is ready for use. The front panel volume control should be set to the desired
signal level.
POWER SUPPLY REQUIREMENTS
In common with all electrical appliances, the OBH-11 needs a power source. The
requirements for the OBH-11 is 24 Volts DC at 150 milli Amps current. A custom
power supply has been provided to run it, which must be connected to the unit via
the DC inlet (2.1mm positive centre pin power jack) on the rear panel. The power
supply adaptor should be plugged into the mains socket which should be matched
for the voltage of the country of use.
N.B. Due to the circuitry charging-up it is normal to hear a small thump through the
headphones during switch-on.
Note 1: The OBH should be placed away from transformer hum fields for
low noise operation.
Note 2: When new, it is necessary for the OBH to be 'burned-in' for at least
24 hours before its full sound quality potential can be realised.
Note 3: Listening to excessive sound pressure levels can seriously damage
your hearing. Be careful and enjoy the music.
WIRING DIAGRAMS
OBH -11
CD
Player
OBH -11
CD
Player
OBH -11
CD
Player
Option 1
OBH
Power Supply
OBH
Power Supply
Option 2
Amplifier
Amplifier
Option 3
OBH
Power Supply
Tape
Deck
Advertisement
