One-Touch Timer Recording - Emerson EWR10D4 Owner's Manual

Video
DVD-R DVD-R
DVD-RW DVD-RW
This is a simple way to set the
recording time in blocks of 30
minutes. Check that the disc you
are recording onto has enough
space for the time you set.
When the recording finishes the
recorder automatically goes into
standby.
1
Turn on the DVD recorder
and load a recordable disc.
Make sure that the TV input is set
on the DVD recorder.
This operation may take a
while to be recognized.
2
Select a recording speed
using REC SPEED button.
Refer to "Recording speed" on
page 26.
3
Make sure that the recording
format is set to the desired
mode.
Refer to "Formatting a disc" on
pages 28-30.
When a DVD-RW disc is
loaded:
You can choose Video mode or
VR mode from SETUP menu.
"Video mode" has been selected
as the default. Refer to pages 28-
29 "Settings for the recording for-
mat to a blank disc."
When a DVD-R disc is loaded:
DVD-R discs will always be in
Video mode.
Recording

One-touch timer recording

VR
DVD-RW DVD-RW
4
Select a desired channel to
record using CH K / L but-
tons or number buttons.
5
Press REC button on the
remote control or the front
panel, then press REC button
repeatedly until a desired
recording time (30 minutes
to 4 hours) appears on the TV
screen.
Recording will start.
I
0:30
0:30
Normal REC
4:00
When reaches the specified time,
the DVD recorder will be turned
off automatically.
To cancel the one-touch timer
recording within the specified
time, press STOP C button.
This operation may take a
while to be completed.
1:00
3:30
POWER OPEN/CLOSE
TIMER
DISPLAY PROG.
A
.@/: ABC DEF
4
1 2 3
CH
GHI JKL MNO
4 5 6
REC
PQRS TUV WXYZ
MONITOR
7 8 9
2
REC SPEED CLEAR SPACE CM SKIP
0
REC
PAUSE
5 SKIP
F H G
B
PLAY
REV FWD
h g
STOP
C
SETUP
TOP MENU MENU/LIST
K
ENTER
REPEAT
{ B
ZOOM RETURN
L
Note
The DVD recorder will be
turned off automatically under
the conditions following.
• No space remained on the
disc.
• When a power failure occurs.
5
33