Cleaning And Replacing The Air Lter - Hitachi CPWX8 User's Manual And Operating Manual

Cleaning and replacing the air filter
Please check and clean the air lter periodically. When the indicators or a message
prompts you to clean the air lter, comply with it as soon as possible. The air lter has two
kinds of lters inside. Replace the lters when they are damaged or too soiled. To prepare
the new lters, make contact with your dealer and tell the following type number.
Type number :
When you replace the lamp, please replace the air lter. An air
lter of specied type will come together with a replacement
lamp for this projector.
1.
Turn the projector off, and unplug the power cord. Allow the
projector to sufciently cool down.
Use a vacuum cleaner on and around the lter cover.
2.
Pick and pull up the lter cover knobs to take it off.
3.
Use a vacuum cleaner for the lter vent of the projector.
4.
Take the ne meshed lter out while holding the ltercover.
5.
It is recommended to leave the coarse meshedlter in the
lter cover as it is.
Use a vacuum cleaner on both sides of the ne meshed
6.
lter while holding it so it will not be sucked in. Use a
vacuum cleaner for the inside of the lter cover to clean
up the coarse meshed lter. If the lters are damaged or
heavily soiled, replace them with new ones.
Put the ne meshed lter on the coarse meshed one,
7.
turning its stitched side up.
Put the lter unit back into the projector.
8.
Turn the projector on and reset the lter time using the
9.
FILTER TIME item in the EASY MENU.
(1) Press the MENU button to display a menu.
(2) Point at the FILTER TIME using the ▼/▲ button, then
press the ► button. A dialog will appear.
(3) Press the ► button to select "OK" on the dialog. It
performs resetting the lter time.
WARNING ►Before taking care of the air lter, make sure the power cable
is not plugged in, then allow the projector to cool sufciently.
►Use only the air lter of the specied type. Do not use the projector without the
air lter or the lter cover. It could result in a re or malfunction to the projector.
►Clean the air lter periodically. If the air lter becomes clogged by dust or the like,
internal temperatures rise and could cause a re, a burn or malfunction to the projector.
NOTE • Please reset the lter time only when you have cleaned or replaced
the air lter, for a suitable indication about the air lter.
• The projector may display the message such as "CHECK THE AIR FLOW" or
turn off the projector, to prevent the internal heat level rising.
14
(Filter set)
UX36761
2
Filter cover
3
Filter cover knobs
4
Intake vent
7
Filter (coarse meshed)
Filter (ne meshed)
Stitched
side