Hitachi CM813ET User Manual page 11

Use a signal cable with the D-Sub Mini 15-pin Connector.
l", ,,,
In
m-mnarti~n
e
5
N(.
"",,,, "".,.
6 Red Ground
7 Green Groul
8
Rl, ka (km Inr
9
10
".
Id
I
-,-" -, "",,
No connect~n
Ground
No connection
;; Bi-directional Data [SDA]
13 H. Sync. (or H/V)
14
v Sy
PJcW
15
Datan;iock [SCL]
If
the graphics board supplies more than one type of sync. signal, the sync,
signal type will be automatically selected by the monitor, with the priority
shown in"the following table.
Sync. Signal Type
Priority
H, V Separate Sync.
1
H I V Composite Sync.
2
Sync. on Green Video
3
4. Power On
Turn on the Power Switch of the monitor first, then the computer.
Refer to Page I.1 "POWER ON/OFF.
NOTICE :
After turning OFF the switch, wait at least 5 seconds to restart the monitor.
Otherwise the monitor may operate unusually.
If the picture doesn't appear, turn OFF the power switch, make
sure of the
following and wait at least 30 seconds to
restart the monitor.
Make sure
the power switch of the computer, power cord connection, signal cable
connection and the input sync. signal are right.
If the Colour is impure on the screen after turning ON the monitor, wait for about
10 minutes and press the
Degauss button.