Connection To The Video Signal Terminals; Connection To The Rgb Signal Terminal - Hitachi CPX940E Operating Manual

Connection to the video signal terminals
1. Input signal
S-VIDEO signal
Luminance signal 1.OVp-p, 75Q termination
Chrominance signal 0.286VP-P (burst signal), 75!2 termination
VIDEO signal
1.OVp-p, 75S2 termination
Input
200mVrms, 20kQ below (MAX 3. OVp-p)
AUDIO signal
output
O-200mVrms, 1Id2
2. Signal input terminal
Chrominance signal Luminance signal
Ground
Ground
S VIDEO input (Mini DIN4 pin)
@iE)
Video input signal terminals have priority in the following order.
OS-VIDEO input terminal @RCA jack input terminal
Even when the video signal is displayed, only an audio signal is output to RGB audio output terminals.
Connection to the RGB signal terminal "
1. Input/ output signal
Video signal I Analog 0.7Vp-p 75Q termination (Positive polarity)
I
I Horizontal sync signal I TTL level (Positive/negative polarity)
I
Vertical sync signal
TTL level (Positive/negative polarity)
I Composite sync signal I TTL level
I
Input 200mVrms, 20kQ below (MAX 3. OVp-p)
Audio signal
output O-200mVrms, 1I@
2. Signal input/ output terminal
1 ] Video signal (Red) I 9 ] N.C
I
2 Video signal (Green) 10 Ground
3 Video signal (Blue) 11 N.C
4 I N.C I 12 I DDC (Display Data channel) RGB1 only I
5 I N.C I 13 I Horizontal/Composite sync signal I
6 I Ground (for R)
I 14 I Vertical sync signal
I
#
I
I
7 I Ground (for G) I 15 I DDC (Display Data channel)
RGB1 only
8 I Ground (for B)
1 ,fmg
00000 6
00000
'15 11
D-sub 15pin shrink terminal
(Female)
@@
Do not use RGB cable other than that specified.
Some RGB cable may not operate DDC (Display Data Channel).
With other cables, pins @ , @ are sometimes not connected.
20