Hitachi CM802ET User Manual page 6

A NOTICE
INSTALL THE UNIT IN AN ADEQUATE ENVIRONMENT!
DO NOT expose this monitor to rain or moisture to prevent electric shock or fire
hazard. This unit is designed to be used in an office or business environment.
DO NOT
subject the unit to vibrations, dust or corrosive gases.
KEEP IN A WELL VENTILATED PLACE!
DO NOT cover this monitor or place anything against any sides (not only the top,
right and left side but also the rear and bottom side) of unit. Ventilation holes are
provided at all sides of the rear cover to prevent the temperature from rising.
KEEP AWAY FROM HEATING RADIATION OR SOURCE!
AVOID placing the unit in direct sunshine or near a heating appliance.
BE CAREFUL OF MAGNETIC FIELDS!
DO NOT place a magnet, loudspeaker system, floppy disk drive, printer, or
anything which will generate magnetism near the unit. A magnetic field may cause
blurred colours or distortion of the displayed pattern.
2. Power Cord Connection
1. Make sure to use a power cord meeting the safety standard of the
country in which you are using the monitor.
2. Insert the connector of a power cord to the "AC Inlet" of the monitor.
3. Insert the plug of the power cord to a receptacle of the correct voltage.
the correct voltage
~
&r
. . . . . . . . . . . . . . . . . . .
\
. . . . ..<
. . . . . . . . . . . . . .
AC Inlet r
E " Pow(Corc7%
A ..-..-. -..+-- 1- -.$
1
a
J
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
1 ..
m
REAR VIEW
A
NOTICE
In Europe , a proper European standard approved power cord is to be used with
this monitor. For a rated current up to 6A, a type not lighter than H05W-F 3G
0.75mm2 or H05WH2-F 3G 0.75mm2 shall be used.
In USWCanada, use a UL LISTED/CSA LABELLED or CERTIFIED power cord set
meeting the following specifications.
Rating: min. 125Y7A Length: max.3.l m
Type: .9/T or SJT
Plug type NEMA 5-15~ Parallel blade, Grounding type, 125V, 15A
Failure to do so may cause fire or electric shock hazard.
The enclosed power cord shall be used if provided.
Use only the correct voltage power outlet ~th safety ground connection.
100-120 V for USA, Canada, etc.
200-240 V for Europe, etc.
(This monitor will automatically adjust to the input voltage 100- 120/ 200-240 V)
The receptacle should be close to the monitor and easily accessible.
5