Hitachi CM802ET User Manual page 13

~ ADJUSTMENT (Continued)
Item
Select
Adjust
Switch Switch
Function
NO.I:9300K
;olour Select
changes the
&q colourto the
T*J
next mode.
No.2:6500K
v,-
m
.
T*J
. .
V.nw
NO.3:5000K
changes the
------- .- .-. .
*
F
-0+ colour to the
T&L
previous
mode.
NO.4:USER
(if available)
"d *'"'W & [q<
'E;:=r:zzhe "per
simultaneous y.
limit, it makes the Green and Blue
weaker.
When Green or
Blue is selected, *
makes the Green and Blue
~ singly "*
'trong~
is valid When the Green or Blue reaches the
upper hmlt, it makes the Red weaker.
Green
mmdw
,_ T+, ~
makes the Green stronger.
When the Green reaches the upper
simultaneously.
limit, it makes the Blue and Red
weaker.
When Blue or
Red is selected, *
makes the Blue and Red stronger.
-a+
When the Blue or Red reaches the
Golour
& 'Si~~~ 'w
weaker,
upper limit, it makes the Green
3alance
~,ue
*andm
,_;+] , ;T{
makes the Blue stronger.
When the Blue reaches the upper
simultaneous y.
limit, it makes the Red and Green
weaker.
When Green or
Red is selected, *
makes the Red and Green stronger.
-a+ When the Red or Green reaches the
~ singly. "F
is valid
upper limit, it makes the Blue weaker.
Colour (This operation is * ,_a
w
cancels the currently adjusted
Reset
valid only when
colour, and calls the colour
Red, Green or
simultaneously
condition of the previously selected
Blue is selected
for about 2
colour mode.
already.)
seconds.
The mode "No.4:USER" is not factory set, and it is programmable if desired.
After adjustment of "Colour Balance" (Red, Green or Blue) and "STORE" (refer to page 14),
your colour balance will be restored by selecting "No.4: USER".
12