Installation; Grounding Instructions - Continental Electric CE21111 Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

19. Do not operate any heating or cooking appliance beneath this appliance.
20. Be certain the glass tray and roller rings are in place when you operate the oven
21. This appliance should be serviced only by qualified service personnel contact nearest
authorized service facility for examination, repair, or adjustment.
1.
Make sure that all the packing materials are removed from the inside of the door.
2.
WARNING: Check the oven for any damage, such as misaligned or bent door, damaged
door seals and sealing surface, broken or loose door hinges and latches and dents
inside the cavity or on the door. If there is any damage, do not operate the oven and
contact qualified service personnel.
3.
This microwave oven must be placed on a flat, stable surface to hold its weight and the
heaviest food likely to be cooked in the oven.
4.
Do not place the oven where heat, moisture, or high humidity are generated, or near
combustible materials.
5.
For correct operation, the oven must have sufficient airflow. Allow 20cm of space above
the oven, 10cm at back and 5cm at both sides. Do not cover or block any openings on
the appliance. Do not remove feet.
6.
Do not operate the oven without glass tray, roller support, and shaft in their proper
positions.
7.
Make sure that the power supply cord is undamaged and does not run under the oven
or over any hot or sharp surface.
8.
The socket must be readily accessible so that it can be easily unplugged in an
emergency.
9.
Do not use the oven outdoors.
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces
risk of electric shock by providing an escape wire for the electric current. The appliance is
equipped with a cord having a grounding wire with a grounding plug. The plug must be
plugged into an outlet that is properly installed and grounded.
WARNING: Improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. It is recommended that
a separate circuit serving only the oven be provided. The oven is equipped with a 3-prong
grounding plug. It must be plugged into a wall receptacle that is properly installed and
grounded.
Extension Cord
If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3 blade
grounding plug and a 3-slot receptacle that will accept the plug on the microwave oven. The
marked rating of the extension cord shall be equal to or greater than the electrical rating of
the appliance.
Notes:
1. If you have any questions about the grounding or electrical instructions, consult a qualified
electrician or service person.
2.
Neither the manufacturer nor the dealer can accept any liability for damage to the oven
or personal injury resulting from failure to observe the electrical connection procedures.

INSTALLATION

GROUNDING INSTRUCTIONS

Advertisement

Table of Contents
loading

Table of Contents