Table of Contents
Advertisement
Zebra
ZEBRA button
It will switch between the zebra display and the marker display every time the button is
pressed.
Zebra 1 # Zebra 2
* It is not displayed when the [ZEBRA DETECT 2]/[MARKER] is set to [OFF]. (l 123)
Zebra display:
Parts where white saturation (color saturation) is likely to occur (extremely brightly lit or shiny
parts) are displayed with diagonal lines (zebra pattern).
Marker display:
Displays the luminance level of the center of the screen (luminance display frame) in %.
It makes the adjustment of the brightness of the object easier, by checking the luminance
level of the object, when recording same object in different surroundings.
≥ Marker display is displayed between 0% and 99%. It will be displayed as 99% when it is
over 99%.
≥ You can record an image with little white saturation if you manually adjust the shutter
speed or brightness. (l 54, 56)
≥ The zebra pattern does not appear on the images actually recorded.
≥ It is also possible to adjust the level of the zebra pattern to be displayed. (l 122)
Color Bar Screen
BARS button
Press the BARS button to output a color bar screen to a television or monitor so you can
adjust them.
≥ To cancel, press the BARS button again.
≥ It will be canceled when the unit is turned off.
≥ While the color bar is displayed, a test tone will be output from the headphone terminal,
HDMI terminal and AV multi terminal. (The test tone that is output will be 1 kHz.) It will not
be output from the speaker of this unit.
≥ It is possible to record the color bar screen.
76
VQT3U98
*
*
# Marker
# setting canceled
Advertisement
Table of Contents
