Snooze Alarm / “Touchless” Snooze - Emerson Research iC200 Owner's Manual

SNOOZE Alarm / "TOUCHLESS" SNOOZE
When the alarms turn on in the morning you can activate the SNOOZE control to
catch a few minutes extra sleep. The Snooze function stops the alarm for 9 minutes
and then turns the alarm ' On' again.
There are three ways to activate the Snooze control:
By touching the SNOOZE button on the top panel or the remote control, or by
placing your hand in front of the TOUCHLESS SNOOZE SENSOR on the front
panel.
When the Snooze function has been
activated the appropriate AL 1 or AL 2
indicator flashes in the display.
NOTE: The Snooze Sensor detects the difference in temperature between
you hand and the ambient room temperature and it is quite accurate.
However in the unusual condition where there is almost no difference between
your hand temperature and the room temperature the touchless snooze function
may not operate. In this case please press the SNOOZE button on the top
panel or the remote control.
36
iC200_NCab050307.p65 36 3/5/2007, 11:29