Emerson Research iC200 Owner's Manual page 29

NOTE: After removing the nano adapter remember to slide the 30-pin
connector back to the right position before attempting to install any other
®
iPod adapter.
4.) After installing the necessary adapter in the docking area and making sure that
it is locked in place, mount the support bracket, and then your iPod
adapter so that the 30-pin connector in the docking area is fully inserted into
the 30-pin socket on the bottom of your iPod
If necessary set the "HOLD" switch on your iPod
5.) Press the Power button on the top panel or remote control to turn this system
' On' . Depending on the setting of the Back Light Timer in your iPod
backlighting may turn ' On' and the "Charging" or "Charged" indicator will appear
in the display.
6.) Press the Function button on the
top panel or on the remote control
to select the iPod function.
Your iPod ® will begin to play. It may begin playback with the first song in your
library in alphabetical order by song name, or if the iPod
short time it may begin playback of the same song that was playing before it
was shut off.
iC200_NCab050307.p65
®
28
28
.
®
to the "Off" position.
®
the display
®
was only shut off for
3/5/2007, 11:29
® into the