Advertisement
INSTALLATION PROCEDURE FOR: LYTECASTER®
1000LV, 1000LVE1 & 1000LVE2 LOW VOLTAGE FRAME-IN
LAMPING (Fig. H
)
NOTE: Socket manufacturers have suggested that socket may fail after 3 to 6 relampings. If
this occurs, socket can be replaced by disconnecting male connectors (attached to socket
leads) from female connectors (attached to fixture leads) and replacing it with a new socket
procured through LIGHTOLIER (Fig. H)
1. Make sure that power is OFF when lamping or relamping. Remove LAMP RING
from SOCKET CUP by pulling straight down.
2. Insert LAMP (MR-16) between LAMP SPRINGS until face of lamp sits firmly on GLASS
LAMP GUARD
(Fig. I.)
3. Attach SOCKET to bi-pin prongs on LAMP.
4. Insert LAMP RING with LAMP and GLASS LAMP GUARD back into SOCKET CUP.
NOTE: 1. LOW VOLTAGE FIXTURES should be dimmed only with special dimmers
intended specifically for that purpose. Use Lightolier Lytemode, Scenist, Crescendo VA,
Neptune VA, Precision VA, Easyset VA, Sunrise VA, Radiant VA or equivalent products
by others or variable autotransformers or electronic dimmers intended for use with low
voltage fixtures. 2. Low voltage fixtures may produce audible sound when used with
dimmers, which may be objectional in acoustically critical areas.
TRANSFORMER REPLACEMENT (1000LV, 1000LVE1 and 1000LVE2)
1.
Make sure power is off.
2.
Remove REFLECTOR TRIM from ceiling.
3.
Rotate ROTO CLIPS out of hole area.
4.
Remove J-BOX COVER nearest ceiling opening by lifting SPRING.
5.
Unsplice all wiring.
6.
Remove TRANSFORMER ASSEMBLY from J-BOX by pulling SPRING upward. (Fig. K).
7.
Place TRANSFORMER ASSEMBLY thru ceiling opening.
8.
Remove TRANSFORMER and TRANSFORMER COVER by straightening TABS with pliers
and removing SCREWS. For 1000LVE1 and 1000LVE2, remove TRANSFORMER by
removing NUTS.
9.
Install the new TRANSFORMER on the U-shaped holder with SCREWS and re-tab to the
remaining half of the TRANSFORMER ASSEMBLY. For 1000LVE1 and 1000LVE2, install
the new TRANSFORMER, securing with NUTS.
10. Reassemble TRANSFORMER ASSEMBLY to J-BOX by placing J-BOX COVER TABS into
J-BOX SLOTS and snapping onto SPRING (Fig. K).
11. Rewire Fixture:
A. Splice transformer red leads to white socket leads.
B. Splice transformer black lead to thermal protector blue lead.
C. Splice transformer and thermal protector white leads to supply common lead.
D. Splice thermal protector black lead to supply black lead.
12. Replace J-BOX COVER.
13. Install REFLECTOR TRIM.
KITS (CONTINUED)
INSTRUCTION SHEET NO.
B0607
A
631 Airport Road, Fall River, MA 02720
IS:1000LV
Page 2 of 2
COMPANY
Advertisement
