Resetting The Clock After A Total Memory Loss - Emerson Research CKS2237 Owner's Manual

2. Remove the battery from its package so it is ready to install.
3. Important: Leave the radio power cord connected to your AC outlet. This will
provide power to the SmartSet
battery is removed.
4. Place the radio face down and use a small screw driver to remove the screw
securing the battery holder to the cabinet.
BE CAREFUL NOT TO LOSE THIS SMALL SCREW !
5. Slide the battery holder out of the cabinet. Then remove the original battery
from the holder and insert the new battery into the holder the same way, with
the positive(+) side facing up.
6. Slide the holder with the new battery back into the opening in the cabinet.
7. Replace the screw that secures the battery holder in the cabinet.
8. Place the radio standing up and
confirm that the "BATT. LOW"
indicator is 'Off'.
9. Save these instructions. You'll
have to do this again five to
eight years from now!

RESETTING THE CLOCK AFTER A TOTAL MEMORY LOSS

If you do not change the built in lithium battery within a reasonable period of time
after you see the low battery warning indicator, the lithium battery may become
exhausted and will no longer be able to supply back up power to the SmartSet
internal computer. If the unit is disconnected from the AC outlet after the battery
is exhausted, or if a power interruption occurs, the SmartSet
and the clock will need to be reset when the power is restored. Be sure to install
a fresh lithium battery before you reset the clock, otherwise the clock will need to
be reset each time the power is interrupted.
®
computer memory while the original lithium
11
NEGATIVE(–) SIDE
POSITIVE(+) SIDE
®
®
memory will be lost