External Devices And Connections - Cobra Marine MARINE MR F75-D Owner's Manual

External Devices
And Connections
Installation And Start-Up

External Devices And Connections

Your CobraMarine VHF radio is set up to connect auxiliary devices for navigation,
convenience, and added versatility. As is the case with the antenna, choosing these
devices is best done with the advice and guidance of a knowledgeable dealer.
Standard connectors are provided on the front and back of the transceiver.
Microphone/Speaker Attachment
Microphone/Speaker
Cord Connection Socket
Connect the Microphone/Speaker to the cord socket
located at the left side of the front of the transceiver.
To Connect The Microphone/Speaker Attachment:
1. Align the connector and push it firmly into the socket.
2. Tighten the captive nut to hold the connector in place.
3. Slide the waterproof sleeve over the nut until it seats
in the recess around the socket.
External Speaker (Not Included)
External Speaker
and PA Jack
An External Speaker can provide greater volume to
hear messages than the speaker incorporated in the
CobraMarine microphone/speaker.
To Install An External Speaker:
1. Connect the speaker lead to the standard jack
on the back of the transceiver.
Public Address Speaker (Hailer)
External Speaker
and PA Jack (Not Included)
At times, it may be handy to hail other boats or give
instructions to line handlers on the dock. Your CobraMarine
VHF radio can be switched to operate in the Public Address
mode through an attached PA speaker.
To Install A Public Address Speaker:
1. Connect the PA speaker lead to the standard
jack on the back of the transceiver.
22 English
Installation And Start-Up
Global Positioning System (GPS) Device (Not Included)
•
Cobra strongly recommends that you obtain and connect a GPS device to
®
your CobraMarine VHF radio. By having a GPS connected, your position will
be continuously indicated on the LCD and, most importantly, it will be included
automatically in any DSC distress message you may need to send. That will
take the "search" out of "search and rescue."
GPS Connection
External Devices
And Connections
To Install A GPS Device:
1. Install the GPS device in a convenient location
according to its manufacturer's directions.
2. Bond the NMEA out negative wire to the black
wire of the GPS interface cable.
3. Bond the NMEA out positive wire to the red
wire of the GPS interface cable.
NOTE
When bonding the wires, make sure connections
are secure and properly insulated.
4. Connect the new combination cable to the GPS
device and to the back of the transceiver.
NOTE
Satellite acquisition time is dependent on the
GPS device.
Nothing Comes Close to a Cobra 23
®