eMachines Notebooks User Manual page 60

3. To remove an existing hard drive assembly, first remove the hard drive
retaining screw 1. Then, grasp the hard drive and slide the assembly
completely out of the hard drive compartment 2.
4. To install the new hard-drive assembly, position the hard-drive assembly as
shown in the previous illustration and slide the assembly completely into the
open compartment.
5. Replace the hard drive retaining screw, reinsert the battery pack, and
reconnect your cables.
6. Perform a system restore to load your notebook's original shipping
configuration onto this hard drive.
See chapter 6,
7. Reload the programs, files, and information from your backup CD onto your
new hard drive.
"system restore," for instructions.
62
getting started