Remote Control Code - Panasonic SC-HTB170 User Manual

Others

∫ Remote control code

When other Panasonic devices respond to this system's
remote control, change the remote control code on this
system and the remote control.
Preparation
≥ Turn off all other Panasonic products.
≥ Turn on the main unit.
Change the remote control code to code 2:
1 Aim the remote control at the main unit's
remote control sensor.
2 Press and hold [MUTE] and [
control for more than 4 sec.
≥ All the indicators will blink for 10 sec when the code of
this system is changed.
≥ The setting is maintained until it is changed again.
≥ If the main unit does not operate after changing the code,
repeat steps 1 and 2.
≥ To change the remote control code to code 1, repeat the
steps above, but replace
∫ To reduce the clear-mode dialog effect
When the dialog does not sound natural while the volume
is set low, It is possible to reduce the dialog enhancing
effect as follows:
While pressing and holding [SOUND] on the remote
control, press and hold [s VOL] on the main unit for more
than 4 sec.
≥ All the indicators will blink once when the clear-mode dialog
effect is reduced.
≥ Even if clear-mode dialog effect is reduced, dialog effect
level is still adjustable.
To reset the setting, return to the factory preset. (
] on the remote
[ ]
with [INPUT SELECTOR].
26)
∫ To turn off VIERA Link "HDAVI
Control"
When "HDAVI Control" compatible equipment does not
work well with this system, for example, it is possible to
turn off this function as follows:
≥ When VIERA Link is turned off, the ARC function is not
available. Be sure to connect the optical digital audio
cable. ( 15)
1 While pressing and holding [MUTE] on the
remote control, press and hold [s VOL] on the
main unit for more than 4 sec.
2 After the setting has changed, turn off all the
connected devices and then turn them on
again.
≥ All the indicators will blink once when VIERA Link "HDAVI
Control" is turned off.
To reset the setting, return to the factory preset. (
∫ To turn off the volume limitation
If a state of the lowered volume disturbs you every time
the main unit turns on, for example, it is possible to turn off
this function as follows:
While pressing and holding [MUTE] on the remote control,
press and hold [VOL i] on the main unit for more than
4 sec.
≥ All the indicators will blink once when the volume limitation
is turned off.
To reset the setting, return to the factory preset. (
26)
26)
25
RQT9841