Cisco Linksys WUSB600N User Manual page 10

Chapter 3
5. The Adapter connects to the network.
Connecting to the Network via Wi-Fi Protected Setup
NOTE: If the connection cannot be set up, the
message, "Registration failed" appears. If this
happens, use one of two options:
Push Button
•
Protected Setup button
lights up. Then click Connect to try again.
PIN Click Skip, and then go to Enter the
•
Adapter's PIN Number, page 7.
6. The Connected to Your Network screen appears. To
save your network's settings, select Remember this
network. (Saving a network's settings will make it
easier to reconnect to the network.) Click Finish to
exit the Wireless Manager.
Connected to Your Network
Congratulations! The Adapter is connected to
the network.
Wireless-N USB Network Adapter with Dual-Band
Press the router's Wi-Fi
until an LED
Advanced Configuration
Enter the Adapter's PIN Number
Enter the PIN Number
1. Access the web-based utility of the router. (Refer to the
router's documentation for instructions.)
2. On the router's Wi-Fi Protected Setup screen, enter
the Adapter's PIN number in the appropriate field.
Then perform the appropriate action to save the PIN
number; for example, click Register. (Refer to the
router's documentation for instructions.)
NOTE:
Enter the Adapter's PIN number without
the hyphen.
3. The Adapter connects to the network, and the
Connected to Your Network screen appears. To save
your network's settings, select Remember this
network. (Saving a network's settings will make it
easier to reconnect to the network.) Click Finish to exit
the Wireless Manager.
Connected to Your Network
Congratulations! The Adapter is connected to
the network.
7