Table of Contents
Advertisement
Troubleshooting
Problem
Tool will not start.
1. No power at outlet during
2. Internal damage or
Excessive noise
Internal damage or wear. (Carbon
or rattling.
brushes or bearings, for example.)
Overheating.
1. Forcing tool to work too fast.
2. Accessory misaligned.
3. Accessory dull or damaged.
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power supply
before service.
SKU 68364
Possible Causes
charging.
wear. (Carbon brushes or
switch, for example.)
For technical questions, please call 1-800-444-3353.
Likely Solutions
1. Check power at outlet. If outlet is unpowered,
turn off tool and check circuit breaker. If breaker
is tripped, make sure circuit is right capacity
for tool and circuit has no other loads.
2. Have technician service tool.
Have technician service tool.
1. Allow tool to work at its own rate.
2. Check and correct accessory.
3. Keep cutting accessories sharp. Replace as needed.
Page 9
Advertisement
Table of Contents
