3 D Video - Mitsubishi Electric 3D DLP WD-73C11 Basic Owner's Manual

3 D Video

To display 3D content, your Mitsubishi TV requires:
• Active-shutter 3D glasses compatible with any one
of the following:
- A matching external synchronization emitter
connected to the TV's back panel
- DLP link
• A compatible 3D source device connected to the
TV via HDMI and outputting a 3D signal in one of
these formats:
- Frame Packing 1080p/24-Hz or 720p/60-Hz
- Top-Bottom 1080p/24-Hz or 720p/60-Hz
- Side-by-Side format, 1080p, 24/30/60-Hz;
720p, 60-Hz
- Checkerboard format, 1080p, 60-Hz; (lower resolu-
tions may be supported but will not fill the screen)
Off
• Turns off 3D images; displays 3D
content as 2D (you may see two
images).
• Restores normal TV adjustment
options when viewing an ordinary 2D
signal.
Use the Picture > 3D Mode
menu to enable 3D video.
Initial Setup
1.
If your 3D glasses came with a synchronization emitter,
connect the emitter to the 3D GLASSES EMITTER jack.
Place the emitter at the front of the TV where there is a
clear path to the glasses.
Note: No emitter is required if using DLP Link.
3D 3D 3D
GLASSES GLASSES GLASSES
EMITTER EMITTER EMITTER
3D 3D 3D
ANT ANT
GLASSES GLASSES GLASSES
EMITTER EMITTER EMITTER
2.
Power on the TV and the source device.
3.
Connect the source device to the TV's HDMI input.
4.
When the New Device Found screen displays,
name the input.
5.
Press EXIT to close the New Device Found screen.
Automatic
• Switches the TV to 3D mode and selects the
correct 3D format when the TV detects a 3D
signal from an HDMI 1.4a-compliant device.
• Automatically switches the TV out of 3D
mode when receiving a normal 2D signal.
Choice of Source Formats
If your device is not HDMI 1.4a
compliant, you must choose the
correct setting from this list.
For assistance call 1(800) 332-2119
3. TV Features
DIGITAL DIGITAL
AUDIO AUDIO
OUTPUT OUTPUT
L L
R R R
21