Setting The Clock; Auto Clock Setting - Magnavox MDR513H/F7 Owner's Manual

Auto Clock Setting

This unit can set the time and date automatically by
referring to a channel that carries a clock information. If a
PBS (public broadcasting station) is available on Cable in
your area, follow "Auto Clock Setting" below. If not, follow
"Manual Clock Setting" on page 34.
Make sure
• The cable TV connections are correct.
• Channels are set. (Refer to page 29.)
STANDBY-ON STANDBY-ON
.@/: .@/:
GHI GHI
PQRS
PQRS
SETUP SETUP
DISC MENU
DISPLAY
V REPLAY
RAPID PLAY
D.DUBBING
TIMER
Note
• The clock may set itself automatically after you
connect the antenna/cable signal and plug in the
power cord.
• Only the Analog PBS channel Cable TV signal is
effective for auto clock setting.
• For analog auto clock setting, incorrect time may be
obtained depending on the broadcast information. If
this occurs, set the "Auto Clock Setting" to "OFF" at
step 4 above and try "Manual Clock Setting" on page
34.
32 32 EN EN

SETTING THE CLOCK

OPEN/
DTV/TV SOURCE CLOSE
ABC ABC DEF DEF
CHANNEL
JKL JKL MNO MNO
TUV WXYZ
TUV WXYZ
SPACE
SPACE CLEAR
AUDIO REPEAT HDMI
TITLE
O OK
RETURN
V.SKIP
HDD DVD
REC MODE REC
ANALOG AUTO CLOCK SETTING (Cable TV only)
1
Press [SETUP] and use [ / ] to
select "General Setting", then press
[OK].
"General Setting" menu will appear.
2
Use [ / ] to select "Clock", then
press [OK].
"Clock" menu will appear.
3
Use [ / ] to select "Auto Clock
Setting", then press [OK].
4
Use [ / ] to select "Auto", then
press [OK].
Auto Clock Setting
OFF
Auto
Manual
5
Press [SETUP] to exit.
6
Press [STANDBY-ON
unit to the standby mode.
This unit will search for the time only when the
power is in the standby mode. Initially leave it in
standby mode for at least 15 minutes to give this
unit time to set the clock. Once the clock is set, the
unit receives the clock data at 12:00 am & 12:00 pm
when unit is in standby mode. Check the time after
the Auto Clock was set, if it is incorrect time then set
the "Auto Clock Setting" to "OFF" in step 4 above.
Then try "Manual Clock Setting" on page 34.
Manual Auto Clock Setting
If the unit chooses an incorrect PBS channel on Cable
TV, set the PBS channel manually by following the steps
below.
1
Select "Manual" at step 4 above, then
press [OK].
2
Use [the Number buttons] or [ / ]
to enter your Cable TV Analog PBS
channel number, then press [OK].
Set Channel No.
CH 1
3
Press [SETUP] to exit and turn the
unit to the standby mode.
] to turn the