Magnavox MDR513H/F7 Owner's Manual page 115

Symptom
Certain functions of the DVC cannot
operate.
DV audio signal cannot be switched.
No image from HDMI connection.
Setup menu cannot be called up.
TV channels cannot be changed.
Only specific channels do not appear.
The external input channels (such as
L1, L2 or L3) cannot be skipped.
The image from the external device
cannot be displayed or recorded.
Recording is impossible.
Timer recording cannot be
performed.
The picture of the autostart
recording disappears.
When playing back the title
recorded from the autostart
recording, the DTV program
information is displayed and it
cannot be disappeared.
Recording is impossible.
The indication
"
Writing to Disc
does not disappear.
TROUBLESHOOTING
Remedy
• Some functions may not operate depending on the type of DVC. For
example, if the DVC does not support slow playback mode, the slow
playback function is disabled.
• With L3(DV-IN), the disc display menu does not appear unless disc
playback is executed.
• For recording with the DVC, the recording audio signal can be set to 12
bits or 16 bits. However, when 16-bit recording mode is selected, audio
signal cannot be switched. To record an audio signal, set it to 12 bits.
• Check the HDMI connection. (Check the status of the HDMI related
indications.)
• Check whether the connected monitor device or other device supports
HDCP. (This unit will not output a video signal unless the other device
supports HDCP.)
• Check the setting of HDMI.
• Check whether the output format of this unit (HDMI FORMAT) matches
the supported input format of other connected device.
• Setup menus cannot be called up during DVD recording.
• Check if the connections are made securely and correctly.
• Check if the cables are damaged.
• Try channel setting by following the steps on pages 29-31.
• The channels may be set to be skipped. (Refer to pages 30-31.)
• This unit does not skip the external input channels. This is not a
malfunction.
• Try pressing [SOURCE] repeatedly.
• Turn on all connected devices.
• Check if the connections are made securely and correctly.
• It is prohibited to make a recording from 2 minutes before the
programmed start time of a timer recording.
• This unit cannot record programs that contain copy protection signal.
This is not a malfunction.
• The space of the recording media may be used up. Try deleting
unnecessary titles, or exchange it with the recordable media.
• The maximum number of titles or chapters has exceeded. Delete the
unnecessary titles to make enough space or insert a new recordable media.
• Check if the connections are made securely and correctly.
• The internal clock of the unit may have been stopped due to a power
failure that lasted for more than 30 seconds. Reset the clock. (Refer to
pages 32-34.)
• The contents of the autostart recording will be cleared in some cases
(Changing input channel etc.). Refer to page 46.
• In the autostart recording, when you display the DTV program
information, the information will be recorded as the part of the picture.
• Copy-once programs cannot be recorded on DVD. This is not a
malfunction.
• Check if the disc is protected or finalized. Undo the protection or the
finalization.
• DVD-RW once formatted on other unit cannot be recorded on this unit
unless all the contents in the disc are erased.
• Check if the connections are made securely and correctly.
• "
Writing to Disc
" maximum of 20 seconds even after it reached 100%. This is not a
100%
malfunction.
" may remain on screen for the
100%
EN EN 115 115