Size Switching; Displaying Two Screens; Input Signal Screen Display - Hitachi CMP4202E User Manual

OPERATING INSTRUCTIONS (continued)
SIZE button
PinP button
AUTO PinP
RGB 1 RGB 2
MENU
ID

Size Switching

Each time the SIZE button of the remote control or the
monitor is pressed, the screen display size (or display
area) will change in sequence and the status will be
displayed at the bottom of the screen.
• During RGB signal input
NORMAL FULL
*
REAL ZOOM3
• Some types of signals may not be able to switch as desired.
* VGA and W-VGA only
• During VIDEO signal input
(when the optional video unit is attached)
4:3 PANORAMA
FULL MOVIE2
• Depending on the type of signal, in some cases it may not be
possible to switch the size, or switching to some sizes may not be
possible.
<< >>
FULL
RECALL button
VOL
RECALL button
MUTE VOL
SIZE RECALL
SIZE button
VIDEO 1 VIDEO 2
RETURN
ENTER
ID SET
ZOOM1
ZOOM2
MOVIE1

Displaying Two Screens

If the PinP button on the remote control is pressed when
the optional video unit is installed, two screens will
display.
Activating the P-in-P mode from the RGB input screen
Pressing the PinP button one time will display two
screens.
The speaker icon can be shifted left and right by pressing the
and SELECT buttons; the audio
of the video will be output from the
side on which the speaker icon is
located.
The sub-screen can be selected
with the VIDEO1 and VIDEO2
buttons from the status shown in the
diagram to the right.
Pressing the PinP button again will
cancel the two screen display.
V1: Displays the VIDEO input signal of the sub-screen.
Activating the P-in-P mode from the video input screen
Pressing the PinP button one time will display two
screens.
• The speaker icon can be shifted
left and right by pressing the
SELECT buttons; the audio of
the video will be output from the
side on which the speaker icon is
located.
• Pressing the PinP button again will
increase the size of the screen.
• Pressing the PinP button once
again will cancel the two screen
display.
• When VIDEO1 set it to RGB Video, it is not completed in P in P mode.
Refer to two screen table
TIPS
Even if the input of the horizontal / vertical synchronizing signal
(or video signal) stops in the two screen display, the mode will
not change to power save mode.
Please be careful since image retention will occur if display is left
in a two screen display state for a long period of time.

Input Signal Screen Display

The input signal status can be displayed on the screen
by pressing the RECALL button of the remote control.
The display will go out in approximately 3 seconds.
VIDEO
VIDEO2
[COMPONENT]
RGB
RGB1
[RGB]
H : 46.5kHz
Input horizontal
frequency
R1 V1
and
V1 V2
Input terminal name
V : 60Hz
Input vertical
frequency
(Sub-
screen)