Clearance - Goldstar GWHD5000 Owner's Manual

lns_latio_
Proper clearance enhances the _oling efficien_ of the unit and preven_ heat
radiation of _e condenser.
!, If a storm window presen_ interference, fasten a 2" wide wo_ stdp to the inner
window si=liacross the full width of the sill. The wood _rip should be thick
enough to raise the height of the window sill _ _at _e un_ can _ installed
without interference by, _e storm window frame.
2. S_ Figure. BoThe top of the wood _rip should be _proximately 3/4" higher
than the sto_ window frame (Storm Window Frame) or wood _rip (Outdoors)
to help condensa_on to drain pro_rly to _e outside,
3. Install a second wo_ _dp (approximately 6" long by 1V2" wide and same
thinness _ fimt stdp) in the center of the sill flush against the ba_ off the
inner sill. This will rai_ the L bracket as shown Figure. B.
4. If the distance between Storm Wind_ Frame and Wood Strip Mounted on Top,
of Inner Sil! is more _an ! ", two of wood _rips are not n_essary.
Fl,gum, A IFlgum, B
Owner's Manual