Configuring The Rg300Ex（Lite) As A Signal Booster; Connecting The Rg300Ex（Lite) Signal Booster (2) - MSI RG300EX LITE User Manual

M S I R G 3 0 0 E X （ L i t e )
The wizard will now save the settings and will close the screen automatically.
Finishing the installation procedure of your Access Point
After following chapter 4, you can finish the installation procedure:
1. Remove the UTP network cable from your computer.
2. Remove the UTP networking cable from the LAN port of your RG300EX（Lite).
3. Restart your computer.
4. Congratulations! You have now properly installed the RG300EX（Lite).
An explanation how to connect your wireless network using Windows XP and
Windows Vista can be found in chapter
4.0 Configuring the RG300EX（Lite) as a signal booster
Do you already have a wireless network and do you like to increase the range of the wireless signal? Then
connect the RG300EX（Lite) as a signal booster. In order to realize this, several settings of your signal
booster (2) and of your wireless router / access point (1) must be modified.
A 2nd RG300EX（Lite) as signal repeater
4.1 Connecting the RG300EX（Lite) signal booster (2)
1. Turn off your computer.
2. Connect the RG300EX（Lite) to a wall outlet using the supplied power adapter.
3. Connect the supplied UTP network cable to the 'LAN 1' port of the RG300EX（Lite).
4. Connect the other end of the UTP network cable to the network adapter of your computer.
Is my RG300EX（Lite) correctly connected to the wall outlet? You can check this by verifying that the
POWER LED is on.
Page 37 of 52