Reviewing Stored S.a.m.e. Codes; Choosing An Alert Type (Voice Or Siren); To Turn The Alert On And Off; Setting The Alert Volume - Midland WR300 Owner's Manual

WR300 Owner's Manual

Reviewing Stored S.A.M.E. Codes:

To review your saved S.A.M.E. codes, do the following:
a. Press the "MENU" button.
b. Press the "UP" arrow until "COUNTY CODE" is displayed on the screen.
c. Press "SELECT"
d. Use the "UP" arrow to scroll through the S.A.M.E. memory code locations.
e. All empty memory locations will appear as "------".
f. Press the "MENU" button when finished reviewing the S.A.M.E. codes.

Choosing an Alert Type (Voice or Siren):

a. Press the "MENU" button to open menu options.
b. Press the "UP" arrow until Alert Mode is displayed on the screen. Press the "SELECT" button
and "VOICE" will start blinking.
c. If you want the voice alert, press the "SELECT" button.
d. If "VOICE" is chosen, the alert would sound for 8 seconds followed by 5 minutes of weather
broadcast.
e. If you want the siren alert, press the "UP" arrow until "SIREN" is displayed, then press the
"SELECT" button to save your setting.
f. If "SIREN" is chosen, alert tones will sound for 5 minutes or until the "ALERT ON/OFF" button
is pressed.

To Turn the Alert ON and OFF:

To turn the alert on and off, press and hold the "ALERT ON/OFF" button for 5 seconds until you
see "ALERT ON" blinking. While still holding down the button, press the "UP" arrow to switch
between "ALERT ON" and "ALERT OFF." Press the "SELECT" button to save your selection.

Setting the Alert Volume:

a. To set the alert volume, press the "MENU" button.
b. Press the "UP" arrow until "SIREN LEVEL" is displayed.
c. Press the "SELECT" button and "LEVEL HIGH" or "LEVEL LO" will start blinking.
d. Then press the "UP" arrow to choose "LEVEL HI" or "LEVEL LO" volume.
e. Press the "SELECT" button to save your setting.

Selectable Alert Option:

You can program the WR300 weather radio to only sound the voice or siren alert for certain
weather emergency messages. Those messages unimportant to you can be programmed to only
display a message, minimizing annoyance.
To program the emergency messages you want to silence, do the following:
a. To set the selectable alerts press the "MENU" button.
a. Press the "UP" button until "DEFEAT SIREN" is displayed. Press the "SELECT"button.
b. Using the "UP" arrow, scroll through the different alerts you may want to silence.
c. When you have selected one, press the "RIGHT" arrow to change the status of the event from
"ALERT ENABLE" to "ALERT DISABLE."
d. Press the "MENU" button to save your selection and exit the programming option.
Page 9 www.midlandusa.com