Hanna Instruments HI 7632-00 Instruction Manual

Conductivity probe

HI 7632-00 Conductivity Probe

HI 7632-00 is an EC/TDS probe with built-in

NTC sensor which provides temperature compen-

sated conductivity measurements.

It can be used with the following Hanna meters:

BL 983317: 0.00 to 10.00 mS/cm

BL 983318: 0.00 to 10.00 ppt

BL 983327: 0.00 to 10.00 mS/cm

HI 7632-00 probe is warranted for a period of one

year. This warranty is limited to repair or replacement free

of charge.

Damages due to accident, misuse, tampering or lack of

prescribed maintenance are not covered.

If service is required, contact the dealer from whom you

purchased the instrument. If under warranty, report the

model number, date of purchase, serial number and the

nature of the failure. If the repair is not covered by the

warranty, you will be notified of the charges incurred. If

the instrument is to be returned to Hanna Instruments, first

obtain a Returned Goods Authorization Number from the

Customer Service department and then send it with ship-

ment costs prepaid. If the repair is not covered by the

warranty, you will be notified of the charge for repair or

replacement. When shipping any instrument, make sure it

is properly packaged for complete protection.

w w w . h a n n a i n s t . c o m

Table of Contents

Do you have a question about the HI 7632-00 and is the answer not in the manual?

Page 1 If the repair is not covered by the warranty, you will be notified of the charges incurred. If the instrument is to be returned to Hanna Instruments, first obtain a Returned Goods Authorization Number from the Customer Service department and then send it with ship- ment costs prepaid.
Page 2 CONNECTIONS: The wires from the probe cable must be con- nected to the process EC or TDS controller as shown below. The connections are color coded for an easy installation. Note: once the probe is attached to the meter, it is recommended to calibrate it before tak- ing any measurement.