Escient FireBall E-120 Remote Control Manual page 6

Press & Hold the "Set" button on the keyboard until the LED flashes twice.
Slowly enter "997" using the number buttons on the keyboard. The LED will flash twice
again.
Press the "CH-" button on the left side of the keyboard. The LED will flash four times.
Press the Fireball (swoop) source button.
Press & Hold the "Set" button on the keyboard until the LED flashes twice.
Slowly enter:
o 1163 for the FB button
o 1162 for the TB button
o 1164 for the PP button
The LED will again flash twice indicating the programming was successful.
Programming the Universal Source Buttons
Use the following steps to program the TV, VCR, CBL, and AUD source buttons to control
other devices. The following table indicates which device types can be programmed on which
source buttons:
Source Button Device Assignment
TV TV
VCR VCR, Audio Cassette, DVD, LDP, DAT, PVR
CBL Cable, Video Accessories, Satellite, DSS
AUD Amplifier, Tuner, Phono, Misc. Audio, CD, Home Automation, MD
Locate the 4 digit device code for the device you want to control in Appendix A.
Press the source button to be programmed.
Press & Hold the "Code Set" button on the remote until the LED flashes twice.
Enter the 4 digit code using the remote's numeric keypad. The LED will flash twice
indicating the code was accepted.
Note: If the LED does a single long flash then the entered code was not valid for that source
button.
See Appendix B for details and instructions for accessing the other various functions available
on the remote control:
6325 Digital Way Indianapolis, IN 46278 317.616.6789 phone 317.616.6790 fax www.escient.com
FIREBALL REMOTE CONTROL GUIDE WD006-1-1
12/23/2003