Setting The Hard Disk Drive(S); Hard - Epson Endeavor WG Setup Manual

Setting the Hard Disk Drive(s)

The SETUP program lets you select the type of hard disk
drive(s) installed in your computer. If you have two hard disk
drives, the first one is drive 1 and the second one is drive 2. Be
sure to choose the correct setting for both drives.
Follow these guidelines:
installed for drives 1 and 2 If you have only
drive, select Not installed for drive 2
disk
drive, or if you installed this drive, select type 39 for
drive 1. For the Epson 240MB hard disk drive, select type 34.
need to select the drive type that matches your drive. See
"Hard Disk Drive Types" below.
Hard Disk Drive Types
If you installed a hard disk in your computer that is not
the standard Epson 120MB drive (type 33) or 240MB drive
(type 34), you need to select the correct type to match your
drive.
The following table lists the types of standard hard disk drives
you can use. Check this table and the documentation supplied
with your hard disk to find the correct type number for your
drive. (Your drive's documentation should list all the
parameters necessary to identify it in this table.) If none of the
types listed matches your drive, see "Defining your own drive
type" on page 2-23.
2-20 Running SETUP program

hard

one