Epson Stylus COLOR 660 Service Manual page 19

EPSON Stylus Color 660
5.2.1.2 Entering Stylus COLOR 660 SERVICE PROGRAM
To perform any adjustment, you need to enter the
SERVICE PROGRAM first. Read the following instructions and these
steps will bring you to the service program screen.
1. Connect the printer and PC and turn on the printer.
2. Insert Disk 1 for the adjustment program to the floppy disk drive.
3. Execute Setup.exe of Disk 1.
4. The Setup Wizard for the adjustment program "EPSON Stylus
COLOR 600/640/660 SERVICE PROGRAM Version 4.0" starts, and
you can follow the direction indicated by the wizard.
5. The Setup Wizard says "Setup Needs The Next Disk."
6. Take out Disk 1 and insert Disk 2.
7. Program will be installed in your appointed folder.
8. Go to the appointed folder and open the adjustment program.
Chapter 5 Adjustment
9. The following screen appears.
Stylus COLOR 660
10. Choose Stylus Color 660, and click OK. By doing so, the model
NOTE: If you select wrong model name in the above menu between
Figure 5-2. Initial Screen (1)
name will be written in the EEPROM.
Stylus COLOR 640 and 660, the model name will be written
in the EEPROM anyway because SC 640 and 660 have
compatibility. Be careful not to choose wrong model name.
The wrong model name will not be written in EEPROM
between SC 660 and SC 640 or between SC 600 and
SC 660.
Revision A
19