Cartridge Part number Black S020187 Color S020191 Media Media name printer cover EPSON 360 dpi Ink Jet Paper EPSON High Quality Ink Jet Paper control panel EPSON Photo Quality Ink Jet output tray Paper EPSON Photo Quality Glossy Paper EPSON Photo Quality Glossy...
Page 2
Since the quality of any particular brand or type of paper may be changed by the manufacturer at any time, EPSON cannot attest to the quality of any non-EPSON brand or type of paper. Always test samples of paper stock before purchasing large quantities or printing large jobs.
* The figure given is based on continuous printing after ink replacement. The actual print capacity may vary, depending on how often you turn on the printer and how often you clean the print head. ** Ink thaws and is usable after approximately 3 hours at 77 °F (25 °C).
EPSON. 4 - EPSON Stylus COLOR 670 P S B A flash power light P S B A are off When all the lights are off, the printer is not load/eject power button button...
8.) color cartridge (S020191) 5. To end the check, turn off the printer after it prints the check page. Then reconnect the interface cable and turn on your printer and computer. If the check page prints, the problem probably lies in your software settings, the interface cable, or your computer.
Black ink cartridge: S020187 Color ink cartridge: S020191 When you need new ink cartridges, contact your dealer or call EPSON Accessories at (800) 873-7766 or visit our web site at www.epsonsupplies.com (U.S. sales only). In Canada, please call (800) 873-7766 for dealer referral.
If ink gets on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. 4. Lift the cartridge out of the printer and dispose of it carefully. 5. Unwrap the new ink cartridge. Then remove only the yellow part of the tape seal on top.
If ink gets on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. 4. Lift the cartridge out of the printer and dispose of it carefully. 5. Unwrap the new ink cartridge. Then remove only the yellow part of the tape seal on top.
Follow these steps to run the Head Cleaning utility (recommended method): 1. Make sure the printer is turned on but not printing, and both the B black and A color ink out lights are off. (If an ink out light is flashing, replace the ink cartridge before continuing.)
For the best results, load EPSON ink jet paper in the printer whenever you check the print head alignment. 2. If you have an application running, access the printer settings dialog box.
Be sure to keep the printer level as you transport it. After transporting the printer, remove the tape securing the print head and test your printer. If you notice a decline in print quality, clean the print head (see page 8); if output is misaligned, align the print head (see page 10).