Table of Contents
Advertisement
Use this menu to adjust and store your preferred picture settings.
Press the green key to display the PICTURE menu.
1.
Press P– or P+ key to position the cursor onto the adjustment you want to make;
Brightness, Contrast, Colour¹, Hue² or Sharpness¹.
2.
Press
– or
The white bar graph shows the progress of the adjustment.
Repeat steps 1 and 2 until you have completed all the adjustments you want to make.
3.
Press P– or P+ key to select STORE.
4.
Press
– or
screen for several seconds to confirm this action.
Press
to return to normal viewing.
Note:
Any picture adjustments made and not stored will remain at that setting until you change channel or switch off, after
which, they will revert to the previously stored setting.
1. Colour and sharpness will not be shown with RGB picture.
2. HUE will only be displayed on the Menu when viewing a 4.43MHz NTSC signal connected via the Euro-connector (SCART).
See page 27.
The programme menu is an overview of all programmes stored in memory.
Press the yellow key to display the programme menu.
1.
To display programmes 30 to 59 press the right cursor key
changes from 00 – 29 to 30 - 59.
2.
Use the cursor keys P– / P+ /
or 30 - 59 as required.
3.
Use the left cursor key
Press
to return to normal viewing.
Note:
From this menu, pressing the yellow key will access the SETUP menu. This is used for automatic and manual tuning,
(see pages 20 to 24, TUNING YOUR TV).
Use this menu to select and set/cancel the features available to you on your television.
Press the
blue
key to display the FEATURES menu.
1
Press P– or P+ key to position the cursor on the feature you want to use - Source,
Child lock, Sleep timer or Text contrast.
2.
Press
– or
a.
toggle SOURCE between TV, AV1, AV2 and RGB.
b.
activate the CHILD LOCK.
c.
set the SLEEP TIMER.
d.
adjust OSD/videotext contrast (text bar is displayed at the top of the screen when cursor is positioned on
TEXTCON).
Press
to return to normal viewing.
Source switch. With no input connected to any of these sources the TV will show a blank screen, but the OSD will still indicate the
source for several seconds.
Child Lock:
When on, control of the television will only be possible from the hand unit. The four buttons at the front of the TV are
disabled.
Note:
If the remote control batteries become exhausted while the Child Lock is active, you will not be able to operate the TV until they
have been replaced.
Sleep Timer.
Allows you to programme the TV to switch to standby automatically after a selected period of time (see below).
To set a time press the
To cancel the sleep timer press
+ key to change the level of adjustment to your own liking.
+ key to Store the settings. The word STORED will appear on the
Programme Menu
– /
– to return to programme display 00 - 29.
+ key to either:
+ key. to select one of the pre-set times, 15, 30, 45, 60, 90 or 120 minutes.
– until the display shows OFF.
Picture Menu
+ until the programme display
+ to move between programmes 00 - 29
Features Menu
5
PICTURE
BRI
CON
COL
HUE
SHARP
STORE
Select ! "
Adjust # $
PROGRAMME
00 _ _ _ _
10 _ _ _ _
20 _ _ _ _
01 _ _ _ _
11 _ _ _ _
21 _ _ _ _
02 _ _ _ _
12 _ _ _ _
22 _ _ _ _
03 _ _ _ _
13 _ _ _ _
23 _ _ _ _
04 _ _ _ _
14 _ _ _ _
24 _ _ _ _
05 _ _ _ _
15 _ _ _ _
25 _ _ _ _
06 _ _ _ _
16 _ _ _ _
26 _ _ _ _
07 _ _ _ _
17 _ _ _ _
27 _ _ _ _
08 _ _ _ _
18 _ _ _ _
28 _ _ _ _
09 _ _ _ _
19 _ _ _ _
29 _ _ _ _
Select: ! " # $
SET UP
FEATURES
SOURCE
TV
CHILD LOCK
OFF
SLEEP TIMER
OFF
TEXT CON
Select ! "
Adjust # $
Advertisement
Table of Contents
